This is the config of my Voron V2.4 300 LDO Kit Serial: V2.3395
Be aware I see my config as WIP and it can and will change from time to time. I normally do only check-in stuff that is tested and run with the base klipper branch. I am not a developer and use this repo as sort of a backup to house my configuration.
This is the list of hardware/mods which correlate to my printer.cfg
- BTT Octopus v1.1
- Raspberry Pi 3B+
- Galileo 2
- BTT SB2209
- E3D Revo 60w 0.4 nozzle
- Stealthburner
- IDM eddy sensor
- WhoppingPochard Kinematic Bed Mounts
- Nevermore V5 Duo XL
- Neopixel Leds per LDO Kit
- CAN bus
- Common Anomaly Gantry
- ATSS AWD conversion
- Spicy Meatball chamber heater