Mocap gloves for SlimeVR

Hardware

• FlexSensor 2.2" x5

• 10k resistance x5

• Gloves of your choice. I chose to put 2 fingerless glove to make it prettier

• Case: I used this case and modified it to have a hole for the wire

• ESP32: FeatherV2 from AdaFruit

How to build:

I have cut some slit of the glove to waive the flexsensor trough.

Wiring is easy just solder wires to all of the same side of the flex sensor and solder to GND pin. And the other site to the Feather pins

Put the resistances on one side of the Featherv2 and solder all of them together. Solder a wire on the 3v to the joint resistances

And solder the wires to the other side in that order:
A9: Thumb
A7: Index
A2: Middle
A3: Ring
A4: Little

Code

You'll need the Arduino IDE

• ConnectToSlime is for use with the SlimeVR Server
• FullGloveWIFI is for use with server_tester.py
• FullGloveNoWiFi is for use with a serial console