Open source Amiga IDE device driver

Features

• Autoboot
• Works with Kickstart 1.3 and up
• Supports up to 127GB drives
• Supports ATAPI Devices (CD/DVD-ROM, Zip disk etc)
• Boot from ZIP/LS-120 etc
• Boot from CD-ROM*
• SCSI Direct, NSD, TD64 support

Downloads

ROM downloads are available under releases

Currently there are two builds

• lide.rom - Used for boards designed by me that feature an IDE interface (such as CIDER)
• lide-atbus.rom - For AT-Bus style devices i.e AT-Bus 2008 + clone, Matze accelerators etc

Boot from CDROM

Booting from CDROM requires Kickstart 2 or higher and one of the following:

1. CDFileSystem from AmigaOS 3.2.2 loaded with LoadModule
2. BootCDFileSystem from OS 4 either:
   • Added to a custom Kickstart ROM OR
   • Loaded by LoadModule

Hardware implementation

• IDECS1 is asserted when A12 is low and the IDE device's base address is decoded
• IDECS2 is asserted as above but when A13 is low rather than A12
• IDECS2 can instead be routed to a second IDE channel as it's IDECS1 and the driver will detect this
• IDE interface is byte-swapped
• Buffered interface
• D15/14 pulled up with a 10K resistor to allow detection of floating bus when no drive present.
• IDE A0/1/2 connected to CPU A9/10/11 providing 512 Byte separation of registers to allow for MOVEM trick

A reference design for this is the CIDER project

Acknowlegements

This driver uses the movem based fast read / write routines from Frédéric REQUIN's at_apollo_device
The release of the open source at_apollo_device inspired me to work on this.

It is based on jbilander's SimpleDevice skeleton.

Thanks to Stefan Reinauer and Chris Hooper for the Open Source A4091 Driver which has also been a good source of inspiration for this project.
Chris' devtest has also been very helpful for testing the driver.

Third-party notice

reloc.S is adapted from the A4091 open-source driver and is Copyright Stefan Reinauer
mounter.c adapted from the A4091 open-source driver and is Copyright 2021-2022 Toni Wilen
The fast read/write routines for ATA devices are adapted from Frédéric REQUIN's at_apollo_device

License

All software contained that is not provided by a third-party is covered by a GPL 2.0 Only license

lide.device is licensed under the GPL-2.0 only license