Replacement PCB for TS100, adds USB-C PD to every hackers favorite tool!
Hardware is finished and working, software V0.1!
To flash the Otter-Iron short the DFU-jumper shown in the image below while plugging it into your computer. This will put the iron into DFU mode allowing you to flash it via DFU/USB. Run this command to flash the downloaded binary.
$ dfu-util -a 0 -s 0x08000000:leave -D firmware.bin
- Write a better regulation
- Current measurement
- Store last setpoint
- Better Fonts/UI
- PD-Profile cycling
Todo next hardware revision:
- Add barrel jack