EnhancedTouch App

Overview

This is an app for EnhancedTouch powered by BlueJelly.

Supported OS

• Windows10(version1706 or later)
• Mac(Requires OS X Yosemite or later)
• Android(Android 6.0 Marshmallow or later)
• Linux(Requires Kernel 3.19+ and BlueZ 5.41+ installed)
• Chrome OS

Unsupported OS

• iOS

Supported Browser

• Chrome only

Demo

Demo in Applied Haptics Laboratory

How to Use

Before Use

Charge the EnhancedTouch device

• Turn off the device
  • The switch is 1 (outside: on, inside: off)
• Plug the USB micro B to the USB port 2
  • While charging, the device illuminates in red
  • When charging is complete, it turns off

Pairing (only initial use)

• Turn on the device
  • The device vibrates
• Pair the device with your machine
  • The method of pairing depends on the operating system you use
  • The device appears as ETXXX (XXX is the device ID)

Update Firmware (for technical collaborators)

• Turn on the device while pressing the button 3
  • The device does NOT vibrate
• Connect the device with your PC
  • PC recognize the device as an USB Flash memory
  • Delete the "firmware.bin"
  • Upload the new firmware
    • The EnhancedTouch project is available
      • ET9: mbed OS2 (private)
      • ET10: Arduino (under construction)
• Turn off the device

Wear the device

• Make sure that the electrodes 4 contact with your skin
  • Make the housing on the palm side of the wrist
  • You may wear a device on the other side of your wrist if it doesn’t have much hair
• Make USB port and switch facing to you
• Turn on the device
  • The device vibrates
  • If not, charge the device

Use App

• Open the app
• Click "Connect to a device"
  • Select ETXXX on the window
• Click "Start" on Acquistion to monitor the event measured by the device
  • Click "Stop" to stop monitoring
• While acquisition is NOT active, you can control the mode of visual and vibration feedback by clicking "OFF", "Normal", or "Direction" on Visual/Vibration Feedback
• While acquision is active, you can record the event by clicking "Start" on Record
  • Clikc "Stop" to stop recording
  • Then, a record file (csv) will be automatically downloaded
  • You can change the file name as you want