Byte IOT Submission Task this is a simple Arduino-based project that demonstrates how to control an RGB LED with a push button. The project follows a specific sequence for the LED colors as the button is pressed. The circuit consists of:

RGB LED: Three colors (Red, Green, and Blue) are controlled via code. Push Button: A button is used to change the state of the LED.

LED Sequence

Initial State (Circuit On): Red light: ON Green light: OFF Blue light: OFF

First Button Press: Red light: OFF Green light: ON Blue light: OFF

Second Button Press: Red light: OFF Green light: OFF Blue light: ON

CODE SNIPPET USED: const int ledPin = 9; // Define the pin for the LED

void setup() { pinMode(ledPin, OUTPUT); // Set the LED pin as an output }

void loop() { digitalWrite(ledPin, HIGH); // Turn on the LED delay(1000); // Wait for 1 second digitalWrite(ledPin, LOW); // Turn off the LED delay(1000); // Wait for 1 second }