- Android 7
- MESH Support
- Monitor mode
- Frame injection
- Up to kernel v5.8+ ... And a bunch of various wifi chipsets
TP-Link TL-WN722N v2/v3 [Realtek RTL8188EUS], you might find this helpful. In the begining, I am able to enter monitor mode. However after a few days, I found out it doesn't allow to enter monitor mode. I think TP-Link TL-WN722N v2/v3 have automatically updated its driver. Then
- sudo apt update
- sudo apt upgrade
- sudo apt-get dist-upgrade
- reboot
- sudo apt-get install linux-headers-$(uname -r)
- sudo apt install bc
- sudo apt-get install build-essential
- sudo apt-get install libelf-dev
- sudo apt install dkms
- sudo rmmod r8188eu.ko
- git clone https://github.com/keralahacker/tp-link-v3-usb
- cd tp-link-v3-usb
- sudo -i
- echo 'blacklist r8188eu'|sudo tee -a '/etc/modprobe.d/realtek.conf'
- reboot
- cd tp-link-v3-usb
- sudo unzip rtl8188eus-tplink-v3-2022-08.zip
- cd rtl8188eus-tplink-v3-2022-08
- sudo make && make install
- cd .. && sudo rm -rf rtl8188eus-tplink-v3-2022-08
- reboot
Like https://github.com/cccooo/rtl8812au-centos-7.6, forked from aircrack-ng/rtl8188eus and modified for CentOS 7.9 as CentOS Kernel 3.10 contains many code from 4.x
- You will need to blacklist another driver in order to use this one.
echo 'blacklist r8188eu'|sudo tee -a '/etc/modprobe.d/realtek.conf'
- Reboot
- cd rtl8188eus
make && sudo make install
- Reboot in order to blacklist and load the new driver/module.
Use these steps to enter monitor mode.
$ sudo airmon-ng check kill
$ sudo airmon-ng start <interface>
Frame injection test may be performed with (after kernel v5.2 scanning is slow, run a scan or simply an airodump-ng first!)
$ aireplay -9 <interface>
Realtek - https://www.realtek.com
Alfa Networks - https://www.alfa.com.tw
aircrack-ng. - https://www.aircrack-ng.org
And all those who may be using or contributing to it of anykind. Thanks!
https://github.com/keralahacker/tp-link-v3-usb/issues/new
airodump-ng wlan0
airodump-ng --bssid --channel --write test wlan0
aireplay-ng --deauth [any no.] -a -c wlan0
If after restarting your kali machine doesn't recognise your device.. As lot of people are facing the same problem .. I have a solution for you.. Whenever you restart your kali OS Insert the adapter and run the command
sudo rmmod r8188eu.ko
sudo modprobe 8188eu
Disconnect the device and connect again..