Cloud connector installation guide

Install prerequisites

Install system prerequisites:

Requires Python > 2.7.9. Version 3 is not supported by coap library and tls v1.2 is only supported for > 2.7.9.

sudo apt-get update
sudo apt-get install python-pip python-dev

Install application libraries:

sudo pip install -r requirements.txt

Configuration

In the folder cloud_connector use the file config.yml to configure the application. There are sections for device, tsdb and cloud

Device

Only OpenMote devices supported at this moment.

To configure the devices, there should be a read interval (in seconds) and for each device the ipv6 address ana a name

devices:
  read_interval: 5
  mote01:
    name: mote01
    ipv6: bbbb::12:4b00:0615:aaaa

TSDB

Only InfluxDB supported.

Configure parameters for influxDB, like the following example:

tsdb:
  influxdb:
    host: 192.168.1.44
    port: 8086
    user: root
    password: root
    database: iot_values

Cloud

Supported cloud services are AWS IoT, thethings.iO and PubNub.

Each service is configure by it's name if its used: aws, pubnub, thethingsio. There is no need to configure all the services, only one can be configured. The parameters are different depending the cloud configuration parameters.

Also an strategy should be configure for each cloud service.

AWS IoT

cloud:
  aws:
    host: A2KYAWFNAAAAAA.iot.eu-west-1.amazonaws.com
    port: 8883
    ca_path: ../keys/aws-iot-rootCA.crt
    cert_path: ../keys/cert.pem
    key_path: ../keys/privkey.pem

thethings.iO

There need one token for each device, the key of the token must match the device name defined on devices.

cloud:
  thethingsio:
    tokens:
      mote01: l0M5BEaDdzt40VqGy6omEqZyDY62CxA6XwCJixxxxxx

PubNub

cloud:
  pubnub:
    publish_key: pub-c-b3d6a6e3-ce77-4a89-9e0b-49e52edddddd
    subscribe_key: sub-c-d74fa040-16f4-11e6-8bc8-0619f89ddddd

Strategies

It's defined for each cloud service, there are different kinds of strategies: All, MessageLimit, TimeLimit, Variation.

• All: Send all messages.
• MessageLimit: Send a limited maximum number of messages per day.
• TimeLimit: Send message only if there has passed some times between the latest one.
• Variation: Only send message if there is a defined variation of a value. It defines a time_low below no message is sent, a time_high after a message will be sent even if variation threshold has not been reach and variability for each value.

strategy:
  type: Variation
  parameters:
    time_low: 10
    time_high: 300
    variability:
      temperature: 0.5
      humidity: 2
      light: 5

Execution

Run in cloud_connector folder:

python ./cloud_connector.py