This mod aims to mount the Orbiter V2.0 extruder to the Voron Stealthburner & crowncooler assembly.
- It is fully compatible with the rest of the stealthburner system of hot ends & shrouds. A slightly modified version of the stealthburner fan shroud has been included to allow access to the orbiter filament lever.
- Compatible with the Crown Cooler system.
- Has a straight filament path.
- Has an integrated filament sensor beneath the extruder for ERCF. Note that a filament sensor is not explicitly required anymore, but has been kept for legacy reasons.
- Works with cable chains or canbus boards
- Has a hinge feature integrated into the mount, to attach an aesthetic stealthburner shroud.
| Standard Canbus | PG7 Canbus | Cable Chain |
|---|---|---|
 |
 |
 |
| Standard Mount | PG7 Cable Gland Mount | Standard Mount |
There is a variation of the standard mount to incorporate a filament sensor below the extruder. See below.
There are a few inherent issues with the sensored mount so I do not recommend them. I highly recommend using the sensorless mounts instead, along with the Happy Hare ERCF software.
If that answer doesn't satisfy you, there are a number of issues with the sensored mounts:
- requires supports
- sensor breaks the PTFE tube into two
- needs a pretty well calibrated printer to get the tolerance on the ball bearing hole right
- is actually LESS reliable than the sensorless version, as filament shavings from the extruder can work its way down into the ball bearing cavity, which jams it open
- eventually the filament rubbing on the hole around the ball bearing starts to wear through it and enlarge it
- [COMPLETE] Initial release!
- [COMPELTE] Add ERCF filament sensor version
- [COMPLETE] Add PG7 cable gland mount version
- [COMPLETE] Assembly instructions
- spacelab_2021, for providing the starting point I used in developing this mod
- KayosMaker, modified parts to make the canbus mounts