The official Micron BOM is here.
If you want to purchase full kits there are 3 available
Formbot Micron+ (180x180) Kit (Affiliate Link)
Funssor Micron (120x120) Kit (Affiliate Link)
Funssor Micron+ (180x180) Kit (Affiliate Link)
120x120 build
| Misumi Part # | Qty | Notes |
|---|---|---|
| HFS3-1515-300 | 4 | Blind holes need to be drilled |
| HFS3-1515-220 | 10 | Ends need to be tapped (M3) |
| HFS3-1515-205 | 2 | |
| HFS3-1515-190 | 1 | |
| HFS3-1515-120 | 1 |
| Part | Qty | Length |
|---|---|---|
| MGN7H | 6 | 150mm |
| MGN9C OR MGN9H | 1 | 150mm |
180x180 build
| Misumi Part # | Qty | Notes |
|---|---|---|
| HFS3-1515-350 | 4 | Blind holes need to be drilled |
| HFS3-1515-280 | 10 | Ends need to be tapped (M3) |
| HFS3-1515-265 | 2 | |
| HFS3-1515-250 | 1 | |
| HFS3-1515-180 | 1 |
| Part | Qty | Length |
|---|---|---|
| MGN7H | 6 | 220mm |
| MGN9C OR MGN9H | 1 | 220mm |
There are 2 versions of this mod, 1 from Zruncho and the other from a user named Zen3D. Both of them have their uses. I prefer to use the Zen3D kind just for the fact that the screw can go all the way through the printed part. Zrunchos do have a much nicer fitment into the extrusions but they also dont allow the screw to go all the way through.
Thanks to the following people on Discord who have helped get this printer finished:
- @TheWarolf#1247
- @L.e.o.p.a.r.d#0990
- @deepfriedheroin#5006
- @JosAr#0517
- @sentein#3903
- @madcat#7838
- @Kyrios#5486
- @faithblinded#1491
- @zruncho#1790
- @Finn#2449
- @clee#1337
- @slidr#4412
- @gfunnymoney#3748
- Jason from LDO
- Voron Dev Team